Rjs Inspector D4000 Laser (FIRMWARE version A.05 and E Bedienungsanleitung PDF herunterladen (Seite 56)

Appendix H Operator’s Guide

RJS, Minneapolis, MN 002-5568

Figure 1 – Scanning angle and distance

Scan distance – See Fig. 2

Scan Angle 30 degrees

From Vertical

Figure 2 – Optimum beam width and placement

Bar code centered in laser beam

*2W

* Adjust scan distance at minimum 2” (51 mm) or the width of the laser beam is approx-

imately two times the width of the bar code.

Special Considerations

When scanning codes on a low contrast substrate like brown corrugated material or a

specular substrate such as shiny aluminum or plastic material, a scan angle other than 30

degrees from vertical may produce better decoding characteristics. Contact RJS Technical

support if scanning problems occur.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 80 81

Keine Kommentare

Rjs Inspector D4000 Laser (FIRMWARE version A.05 and E Bedienungsanleitung Seite 56